Changing The Yoke - Car-O-Liner CR510 Instruction Manual

Car-O-Liner AB
3
2

4.6.3 Changing the yoke

By-pass
connection
Yoke
32
Changing the cap
1. Turn off the water cooling.
25. Grab the piston electrode at the end and hold the electrode in place
with a 16 mm wrench (5/8").
2. Twist the cap off with a suitable tool.
To access hard to reach areas, the CR500 range c-tong can be fitted with dif-
ferent yokes. The following yokes are supplied with the c-tong:

Yoke, 80 mm (3.2")

Extension yoke, 330 mm (13.2")
The c-tong can also be fitted with the following yokes, which are available
as accessories. (510, 530) By-pass connection must be used when using the
600 mm yoke and fender edge yoke.

Extension yoke, 600 mm (24")

Fender edge yoke
The yokes are changed as follows:
NOTE: (510,530) Make sure that the cooling unit is turned off before loos-
ening the yoke.
1. Loosen the yoke by turning the handle counter-clockwise.
2. Remove the yoke from the c-tong.
3. Insert the extension yoke onto the c-tong.
4. Fasten the extension yoke by firmly turning the handle clockwise.
5. (510,530) Perform a manual impedence calibration when changing
the yoke, see section 4.10.6 "Setting up User 2".
WARNING! It is very important to turn the handle firmly to secure the
yoke.
CR500 range
35201, ENG - rev. 3, 2006-03