Remove the six screws (D) securing the bracket.
8.
Gently detach the bridge PCBA from the upper engine PCBA.
9.
10.
Remove the bracket.
Remove the three screws (E) securing the bridge PCBA to the bracket.
11.
12.
Remove the bridge PCBA.
C toner auger removal
Remove the printer front door. See
1.
Remove the transfer belt cleaner. See
2.
3.
Remove the waste toner box.
Remove the four photoconductor units.
4.
Remove the four toner supplies.
5.
Remove the operator panel front cover.
6.
Remove the printhead retract door. See
7.
8.
Remove the inner cover. See
Remove the inner plate. See
9.
"Printer front door removal" on page
"Transfer belt cleaner removal" on page
"Printhead retract door removal" on page
"Inner cover removal" on page
"Inner plate removal" on page
4-10.
4-172.
4-139.
4-3.
4-92.
Repair information
5058-030
Previous
Next
Go Back
4-31