Rip Pcba Removal - Lexmark C950 Service Manual

5058-030
Remove the two screws (A).
7.
Disconnect the cable (B).
8.
9. Remove the registration/transport roller assembly.

RIP PCBA removal

Before you replace the RIP PCBA, make sure you back up the eSF solutions and settings. See
backup" on page
Warning: If you are replacing the RIP PCBA in addition to the operator panel or the operator panel PCBA, you
must replace one component at a time. After you replace one component, perform a POR on the
Service Manual
4-144
4-146.
Previous
Next
Go Back
"eSF solutions