Energy Conserve; Envelope Prompts; Erase All Information On Disk; Exit Tray 2 - Lexmark C950 Service Manual

5058-030
To change this setting:
1. From the Configuration Menu, navigate to Disk Encryption.
Select Disable or Enable.
2.

Energy Conserve

This setting affects the values that display in the "Sleep Mode" setting. With Energy Conserve set to Off, this
menu displays Disabled which, when selected, deactivates the Sleep feature. When Energy Conserve is set to
On, Disabled does not appear in the Sleep Mode menu.
To change this setting:
1. From the Configuration Menu, navigate to Energy Conserve.
Touch or
2.
Touch Submit to save the setting, or touch Back to return to the Configuration Menu without saving any
3.
changes.

Envelope Prompts

This setting controls the input source to which a device will direct an envelope change prompt. The device
displays envelope prompts based on the size of the envelope requested by the user, not on the envelope type.
To change this setting:
1. From the Configuration Menu, navigate to Envelope Prompts.
Touch or
2.
3. Touch Submit to save the setting, or touch Back to return to the Configuration Menu without saving any
changes.

Erase all Information on Disk

To run this operation:
From the Configuration Menu, navigate to Erase all Information on Disk.
1.
2. Touch Single Pass Erase or Multiple Pass Erase.

Exit Tray 2

To change this setting:
From the Configuration Menu, navigate to Exit Tray 2.
1.
Touch or
2.
3. Touch Submit to save the setting, or touch Back to return to the Configuration Menu without saving any
changes.

Factory Defaults

Warning: This operation cannot be undone.
This setting enables a user to restore all of the device's settings to either the network settings (on network
models only) or to the base device settings.
To restore the Factory Default settings:
1. From the Configuration Menu, navigate to Factory Defaults.
Touch Restore Base to restore all non-critical base printer NVRAM settings.
2.
Service Manual
3-8
to change the setting.
to change the setting.
to change the setting.
Previous
Next
Go Back