Finisher Pcba Removal - Lexmark C950 Service Manual

Remove the entrance drive pulley 20T (F).
12.
13. Remove the bushing (I).
Remove the e-clip securing the media entrance roll assembly (H) to the front of the finisher.
14.
15. Remove the bushing (J).
I
F
G
Rear
Move the media entrance roll assembly (H) toward the rear, downward, and then forward.
16.
17. Remove the media entrance roll assembly (H) through the inside of the finisher.
Note: When removing the media entrance roll assembly (H), do not touch the rubber surface.
Reinstallation notes:
• Make sure the flat spot on the media entrance roll assembly (H) is installed to the rear.
When replacing the media entrance roll assembly (H), do not touch the rubber surface.
•
The tension of the belt (entrance/paddle) (E) is automatically adjusted to the force of the spring attached to
•
the belt tensioner bracket (D).
• Tighten the two screws in the order shown.

Finisher PCBA removal

Remove the rear upper cover. See
1.
Remove the rear lower cover. See
2.
3. Loosen the four screws securing the plate (A) to the finisher.
H
J
H
E-clip
Front
"Rear upper cover removal" on page
"Upper media bin front cover removal" on page
5058-030
4-309.
4-353.
Repair information
4-281
Previous
Next
Go Back