Sensor (Media Eject Shaft Hp) Removal - Lexmark C950 Service Manual

5058-030
Remove the two media eject unit springs attached to the media eject unit assembly by pushing them
3.
downward.
Remove the media eject clamp motor assembly. See
4.
5. Release the hooks of the sensor (media eject clamp HP) (A) from the bracket (B).
Remove the sensor (media eject clamp HP) (A).
6.

Sensor (media eject shaft HP) removal

Remove the rear upper cover. See
1.
2. Disconnect the connector from the sensor (media eject shaft HP) (A).
Rotate the media eject clutch actuator (B) by hand so it clears the sensor (media eject shaft HP) (A).
3.
Service Manual
4-324
Right
Springs
B
A
B
"Rear upper cover removal" on page
"Clamp drive motor removal" on page
4-309.
Previous
Next
Go Back
4-268.