Lexmark C950 Service Manual page 561

Release the two clamps (C) to release the harness.
4.
Swing the PCBA door open.
5.
Remove the transfer roll HVPS PCBA. See the
6.
section.
Remove the developer HVPS PCBA. See the
7.
8. Remove the two screws (D) securing the bracket to the machine.
Remove the bracket.
9.
Warning: When disconnecting the two wire harnesses from the motors, make sure that the release hook is
pressed or the connections will be damaged.
"Transfer roll HVPS PCBA removal" on page 4-175
"Developer HVPS PCBA removal" on page 4-69
5058-030
section.
Repair information
4-133
Previous
Next
Go Back