5058-030
Release the hooks securing the sensor (punch waste box set) (A) to the finisher.
4.
Remove the sensor (punch waste box set) (A).
5.
Sensor (stacker bin level encoder) removal
Remove the rear upper cover. See
1.
2.
Disconnect the connector from the sensor (stacker bin level encoder) (A).
Release the harness from the clamp.
3.
4.
Remove the screw securing the bracket (B) from the stacker bin lift motor assembly (C).
Service Manual
4-330
"Rear upper cover removal" on page
A
B
Clamp
C
A
Connector
4-309.
Connector
Clamp
Rear
Previous
Next
Go Back