Hcf Pick Roll Assembly Removal; Hcf Pick Roll Shaft Assembly Removal - Lexmark C950 Service Manual

HCF pick roll assembly removal

Open the HCF top door.
1.
2. Open the HCF feed unit assembly.
Push the two ends of the HCF pick roll assembly (A) inward, and move it upward in the direction of the
3.
arrow to release it from the HCF media feed unit assembly (B).
Remove the HCF pick roll assembly (A).
4.
Note: When removing the HCF pick roll assembly (A), do not touch the rubber surface.
Front
Note: Before re-installing the HCF pick roll assembly (A), do not touch the rubber surface.

HCF pick roll shaft assembly removal

Open the HCF top door.
1.
2. Open the HCF feed unit assembly.
Remove the HCF pick roll assembly. See
3.
Use a prying tool to remove the e-clip securing the HCF pick roll shaft assembly (A) to the HCF media feed
4.
unit assembly (B).
5. Remove the bushing (C) from the HCF media feed unit assembly (B).
Remove the bearing (D) from the HCF media feed unit assembly (B).
6.
A
B
"HCF pick roll assembly removal" on page
5058-030
4-369.
Repair information
4-369
Previous
Next
Go Back