Lexmark C950 Service Manual page 56

5058-030
User status and attendance messages
User primary message Explanation
38 Memory full
39 Complex page,
some data may not
have printed
40 [color] invalid refill,
change cartridge
50 PPDS font error
51 Defective flash
detected
52 Not enough free
space in flash memory
for resources
53 Unformatted flash
detected
54 Network [x] software
error
54 Serial option [x] error Try one or more of the following:
54 Standard network
software error
55 Unsupported option
in slot [x]
Service Manual
2-8
Try one or more of the following:
• Touch Cancel job to clear the message.
• Install additional printer memory.
Try one or more of the following:
• Touch Continue to clear the message and continue printing.
• Cancel the current print job.
• Install additional printer memory.
Replace the specified cartridge to continue printing.
Try one or more of the following:
• Touch Continue to clear the message and continue printing.
• The printer cannot find a requested font. From the PPDS menu, select Best Fit,
and then select On. The printer will find a similar font and reformat the affected
text.
• Cancel the current print job.
Try one or more of the following:
• Touch Continue to clear the message and continue printing.
• Cancel the current print job.
Try one or more of the following:
• Touch Continue to clear the message and continue printing.
Downloaded fonts and macros not previously stored in flash memory are
deleted.
• Delete fonts, macros, and other data stored in flash memory.
• Upgrade to a larger capacity flash memory card.
Try one or more of the following:
• Touch Continue to stop the defragment operation and continue printing.
• Format the flash memory. If the error message remains, the flash memory may
be defective and require replacing.
Try one or more of the following:
• Touch Continue to continue printing.
• Turn the printer off, wait for about 10 seconds, and then turn the printer back
on.
• Upgrade (flash) the network firmware in the printer.
• Check that the serial cable is properly connected and is the correct one for the
serial port.
• Check that the serial interface parameters (protocol, baud, parity, and data bits)
are set correctly on the printer and host computer.
• Touch Continue to continue printing.
• Turn the printer power off and then back on to reset the printer.
Try one or more of the following:
• Touch Continue to continue printing.
• Turn the printer off and then back on to reset the printer.
• Upgrade (flash) the network firmware in the printer or print server.
1. Turn the printer off.
2. Unplug the power cord from the wall outlet.
3. Remove the unsupported option card from the printer system board, and then
replace it with a supported card.
4. Connect the power cord to a properly grounded electrical outlet.
5. Turn the printer back on.
Previous
Next
Go Back