5058-030
Disconnect the connector from the lift tray height sensor (stacker bin level R) (A).
3.
Remove the screw securing the sensor (stacker bin level R) (A).
4.
Remove the sensor (stacker bin level R) (A).
5.
Sensor (stacker bin upper limit) or sensor (stacker bin no media) removal
Remove the rear upper cover. See
1.
Remove the rear lower cover. See
2.
Remove the stacker media bin assembly. See
3.
4.
Remove the stacker bin lift motor assembly. See
page
4-337.
Remove the four screws securing the metal cover (A) to the finisher.
5.
Service Manual
4-332
Connector
A
"Rear upper cover removal" on page
"Upper media bin front cover removal" on page
"High capacity feeder (HCF) removals" on page
"Stacker bin lift motor assembly removal" on
Rear
4-309.
4-353.
4-359.
Previous
Next
Go Back