Dscp-To-Ieee 802.1P Priority Settings; Configuring Dscp Settings - ZyXEL Communications GS2200-24 User Manual

Chapter 30 Differentiated Services

30.5 DSCP-to-IEEE 802.1p Priority Settings

You can configure the DSCP to IEEE 802.1p mapping to allow the Switch to
prioritize all traffic based on the incoming DSCP value according to the DiffServ to
IEEE 802.1p mapping table.
The following table shows the default DSCP-to-IEEE802.1p mapping.
Table 81 Default DSCP-IEEE 802.1p Mapping
DSCP VALUE 0 – 7
IEEE 802.1p

30.5.1 Configuring DSCP Settings

To change the DSCP-IEEE 802.1p mapping click the DSCP Setting link in the
DiffServ screen to display the screen as shown next.
Figure 129 IP Application > DiffServ > DSCP Setting
The following table describes the labels in this screen.
Table 82 IP Application > DiffServ > DSCP Setting
LABEL
0 ... 63
Apply
Cancel
260
8 – 15 16 – 23 24 – 31 32 – 39 40 – 47 48 – 55 56 – 63
0 1 2
DESCRIPTION
This is the DSCP classification identification number.
To set the IEEE 802.1p priority mapping, select the priority level from the drop-
down list box.
Click Apply to save your changes to the Switch's run-time memory. The Switch
loses these changes if it is turned off or loses power, so use the Save link on
the top navigation panel to save your changes to the non-volatile memory when
you are done configuring.
Click Cancel to begin configuring this screen afresh.
3 4 5
GS2200-24 User's Guide
6 7