C
H A P T E R
27.1 Overview
This chapter shows you how to configure the Switch to guard against loops on the
edge of your network.
Loop guard allows you to configure the Switch to shut down a port if it detects that
packets sent out on that port loop back to the Switch. While you can use Spanning
Tree Protocol (STP) to prevent loops in the core of your network. STP cannot
prevent loops that occur on the edge of your network.
Figure 116 Loop Guard vs. STP
Loop Guard
Refer to
Section 27.3 on page 242
27.2 What You Can Do
Use the Loop Guard screen
the Switch and in specific ports.
GS2200-24 User's Guide
Loop Guard
for more information.
(Section 27.4 on page
243) to enable loop guard on
27
STP
241