ZyXEL Communications GS2200-24 User Manual page 205

Table 60 Advanced Application > AAA > RADIUS Server Setup (continued)
LABEL
IP Address
UDP Port
Shared Secret
Delete
Apply
Cancel
Apply
Cancel
GS2200-24 User's Guide
DESCRIPTION
Enter the IP address of an external RADIUS server in dotted decimal
notation.
The default port of a RADIUS server for authentication is 1812. You
need not change this value unless your network administrator instructs
you to do so.
Specify a password (up to 32 alphanumeric characters) as the key to be
shared between the external RADIUS server and the Switch. This key is
not sent over the network. This key must be the same on the external
RADIUS server and the Switch.
Check this box if you want to remove an existing RADIUS server entry
from the Switch. This entry is deleted when you click Apply.
Click Apply to save your changes to the Switch's run-time memory. The
Switch loses these changes if it is turned off or loses power, so use the
Save link on the top navigation panel to save your changes to the non-
volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
Click Apply to save your changes to the Switch's run-time memory. The
Switch loses these changes if it is turned off or loses power, so use the
Save link on the top navigation panel to save your changes to the non-
volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
Chapter 25 AAA
205