Ftp Command Line Procedure; Gui-Based Ftp Clients - ZyXEL Communications GS2200-24 User Manual

Be sure to upload the correct model firmware as uploading the
wrong model firmware may damage your device.

32.7.3 FTP Command Line Procedure

Launch the FTP client on your computer.
1
Enter open, followed by a space and the IP address of your Switch.
2
Press [ENTER] when prompted for a username.
3
Enter your password as requested (the default is "1234").
4
Enter bin to set transfer mode to binary.
5
Use put to transfer files from the computer to the Switch, for example, put
6
firmware.bin ras transfers the firmware on your computer (firmware.bin) to the
Switch and renames it to "ras". Similarly, put config.cfg config transfers the
configuration file on your computer (config.cfg) to the Switch and renames it to
"config". Likewise get config config.cfg transfers the configuration file on the
Switch to your computer and renames it to "config.cfg". See
for more information on filename conventions.
Enter quit to exit the ftp prompt.
7

32.7.4 GUI-based FTP Clients

The following table describes some of the commands that you may see in GUI-
based FTP clients.
General Commands for GUI-based FTP Clients
COMMAND
Host Address
Login Type
Transfer Type
GS2200-24 User's Guide
DESCRIPTION
Enter the address of the host server.
Anonymous.
This is when a user I.D. and password is automatically supplied to
the server for anonymous access. Anonymous logins will work only
if your ISP or service administrator has enabled this option.
Normal.
The server requires a unique User ID and Password to login.
Transfer files in either ASCII (plain text format) or in binary mode.
Configuration and firmware files should be transferred in binary
mode.
Chapter 32 Maintenance
Table 88 on page 276
277