ZyXEL Communications GS2200-24 User Manual page 327

• If you changed the IP address and have forgotten it, see the troubleshooting
suggestions for
Check the hardware connections, and make sure the LEDs are behaving as
2
expected. See
Make sure your Internet browser does not block pop-up windows and has
3
JavaScripts and Java enabled.
Make sure your computer is in the same subnet as the Switch. (If you know that
4
there are routers between your computer and the Switch, skip this step.)
Reset the device to its factory defaults, and try to access the Switch with the
5
default IP address. See
If the problem continues, contact the vendor, or try one of the advanced
6
suggestions.
Advanced Suggestions
• Try to access the Switch using another service, such as Telnet. If you can access
the Switch, check the remote management settings to find out why the Switch
does not respond to HTTP.
I can see the Login screen, but I cannot log in to the Switch.
Make sure you have entered the user name and password correctly. The default
1
user name is admin, and the default password is 1234. These fields are case-
sensitive, so make sure [Caps Lock] is not on.
You may have exceeded the maximum number of concurrent Telnet sessions.
2
Close other Telnet session(s) or try connecting again later.
Check that you have enabled logins for HTTP or Telnet. If you have configured a
secured client IP address, your computer's IP address must match it. Refer to the
chapter on access control for details.
Disconnect and re-connect the cord to the Switch.
3
If this does not work, you have to reset the device to its factory defaults. See
4
Section 4.6 on page
Pop-up Windows, JavaScripts and Java Permissions
GS2200-24 User's Guide
I forgot the IP address for the Switch.
Section 3.3 on page 40.
Section 4.6 on page
49.
Chapter 40 Troubleshooting
49.
327