Power Connector - ZyXEL Communications GS2200-24 User Manual

Pull the transceiver out of the slot.
3
Figure 10 Removing the Fiber Optic Cables
Figure 11 Opening the Transceiver's Latch Example
Figure 12 Transceiver Removal Example

3.2.4 Power Connector

Note: Make sure you are using the correct power source as shown on the panel.
To connect power to the Switch, insert the female end of the power cord to the AC
power receptacle on the front panel. Connect the other end of the supplied power
cord to a power outlet. Make sure that no objects obstruct the airflow of the fans
(located on the side of the unit).
See Chapter 41 on page 329
requirements.
GS2200-24 User's Guide
for information on the Switch's power supply
Chapter 3 Hardware Panels
39