ZyXEL Communications GS2200-24 User Manual page 266

Chapter 31 DHCP
Note: You must set up a management IP address for each VLAN that you want to
configure DHCP settings for on the Switch.
See Section 8.7 on page 78
addresses for VLANs.
Figure 134 IP Application > DHCP > VLAN
The following table describes the labels in this screen.
Table 86 IP Application > DHCP > VLAN
LABEL
VID
Remote
DHCP Server
1 .. 3
Relay Agent
Information
Information
Add
Cancel
Clear
VID
266
for information on how to set up management IP
DESCRIPTION
Enter the ID number of the VLAN to which these DHCP settings apply.
Enter the IP address of a DHCP server in dotted decimal notation.
Select the Option 82 check box to have the Switch add information (slot
number, port number and VLAN ID) to client DHCP requests that it relays
to a DHCP server.
This read-only field displays the system name you configure in the
General Setup screen.
Select the check box for the Switch to add the system name to the client
DHCP requests that it relays to a DHCP server.
Click Add to save your changes to the Switch's run-time memory. The
Switch loses these changes if it is turned off or loses power, so use the
Save link on the top navigation panel to save your changes to the non-
volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
Click this to clear the fields above.
This field displays the ID number of the VLAN group to which this DHCP
settings apply.
GS2200-24 User's Guide