What You Can Do; Configuring Static Routing - ZyXEL Communications GS2200-24 User Manual

Chapter 29 Static Route

29.2 What You Can Do

Use the Static Routing screen
this static route.

29.3 Configuring Static Routing

Click IP Application > Static Routing in the navigation panel to display the
screen as shown.
Figure 125 IP Application > Static Routing
The following table describes the related labels you use to create a static route.
Table 79 IP Application > Static Routing
LABEL
Active
Name
Destination
IP Address
IP Subnet
Mask
Gateway IP
Address
254
(Section 29.3 on page
DESCRIPTION
This field allows you to activate/deactivate this static route.
Enter a descriptive name (up to 10 printable ASCII characters) for
identification purposes.
This parameter specifies the IP network address of the final destination.
Enter the subnet mask for this destination. Routing is always based on
network number. If you need to specify a route to a single host, use a
subnet mask of 255.255.255.255 in the subnet mask field to force the
network number to be identical to the host ID.
Enter the IP address of the gateway. The gateway is an immediate
neighbor of your Switch that will forward the packet to the destination.
The gateway must be a router on the same segment as your Switch.
254)
to activate/deactivate
GS2200-24 User's Guide