Configure Rapid Spanning Tree Protocol - ZyXEL Communications GS2200-24 User Manual

Chapter 13 Spanning Tree Protocol
The following table describes the labels in this screen.
Table 26 Advanced Application > Spanning Tree Protocol > Configuration
LABEL
Spanning Tree
Mode
Apply
Cancel

13.6 Configure Rapid Spanning Tree Protocol

Use this screen to configure RSTP settings, see
information on RSTP. Click RSTP in the Advanced Application > Spanning
Tree Protocol screen.
Figure 62 Advanced Application > Spanning Tree Protocol > RSTP
122
DESCRIPTION
You can activate one of the STP modes on the Switch.
Select Rapid Spanning Tree, Multiple Rapid Spanning Tree or
Multiple Spanning Tree. See
background information on STP.
Click Apply to save your changes to the Switch's run-time memory. The
Switch loses these changes if it is turned off or loses power, so use the
Save link on the top navigation panel to save your changes to the non-
volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
Section 13.1 on page 117
Section 13.1 on page 117
GS2200-24 User's Guide
for
for more