Transceiver Installation; Transceiver Removal - ZyXEL Communications GS2200-24 User Manual

Chapter 3 Hardware Panels
• Connection speed: 1 Gigabit per second (Gbps)

3.2.3.1 Transceiver Installation

Use the following steps to install a mini-GBIC transceiver (SFP module).
Insert the transceiver into the slot with the exposed section of PCB board facing
1
down.
Press the transceiver firmly until it clicks into place.
2
The Switch automatically detects the installed transceiver. Check the LEDs to
3
verify that it is functioning properly.
Close the transceiver's latch (latch styles vary).
4
Connect the fiber optic cables to the transceiver.
5
Figure 8 Transceiver Installation Example
Figure 9 Connecting the Fiber Optic Cables

3.2.3.2 Transceiver Removal

Use the following steps to remove a mini-GBIC transceiver (SFP module).
Remove the fiber optic cables from the transceiver.
1
Open the transceiver's latch (latch styles vary).
2
38
GS2200-24 User's Guide