ZyXEL Communications GS2200-24 User Manual page 311

Table 107 Management > Cluster Management > Configuration (continued)
LABEL
VID
Apply
Cancel
Clustering
Candidate
List
Password
Add
Cancel
Refresh
The next summary table shows the information for the clustering members configured.
Index
MacAddr
Name
Model
Remove
Cancel
GS2200-24 User's Guide
DESCRIPTION
This is the VLAN ID and is only applicable if the Switch is set to
802.1Q VLAN. All switches must be directly connected and in the
same VLAN group to belong to the same cluster. Switches that are not
in the same VLAN group are not visible in the Clustering Candidates
list. This field is ignored if the Clustering Manager is using Port-
based VLAN.
Click Apply to save your changes to the Switch's run-time memory.
The Switch loses these changes if it is turned off or loses power, so
use the Save link on the top navigation panel to save your changes to
the non-volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
The following fields relate to the switches that are potential cluster
members.
A list of suitable candidates found by auto-discovery is shown here.
The switches must be directly connected. Directly connected switches
that are set to be cluster managers will not be visible in the
Clustering Candidate list. Switches that are not in the same
management VLAN group will not be visible in the Clustering
Candidate list.
Each cluster member's password is its web configurator password.
Select a member in the Clustering Candidate list and then enter its
web configurator password. If that switch administrator changes the
web configurator password afterwards, then it cannot be managed
from the Cluster Manager. Its Status is displayed as Error in the
Cluster Management Status screen and a warning icon (
appears in the member summary list below.
If multiple devices have the same password then hold [SHIFT] and
click those switches to select them. Then enter their common web
configurator password.
Click Add to save your changes to the Switch's run-time memory. The
Switch loses these changes if it is turned off or loses power, so use
the Save link on the top navigation panel to save your changes to the
non-volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
Click Refresh to perform auto-discovery again to list potential cluster
members.
This is the index number of a cluster member switch.
This is the cluster member switch's hardware MAC address.
This is the cluster member switch's System Name.
This is the cluster member switch's model name.
Select this checkbox and then click the Remove button to remove a
cluster member switch from the cluster.
Click Cancel to begin configuring this screen afresh.
Chapter 36 Cluster Management
)
311