Vlan; Chapter 9 Vlan; Overview; What You Can Do - ZyXEL Communications GS2200-24 User Manual

C
H A P T E R

9.1 Overview

This chapter shows you how to configure 802.1Q tagged and port-based VLANs.
The type of screen you see here depends on the VLAN Type you selected in the
Switch Setup screen.

9.2 What You Can Do

• Use the VLAN Status screen
• Use the VLAN Detail screen
settings and status of the VLAN group.
• Use the Static VLAN screen
802.1Q VLAN parameters for the Switch.
• Use the VLAN Port Setting screen
static VLAN (IEEE 802.1Q) settings on a port.
• Use the Subnet Based VLAN screen
that allow you to group traffic into logical VLANs based on the source IP subnet
you specify.
• Use the Port-Based VLAN screen
where the packet forwarding decision is based on the destination MAC address
and its associated port.

9.3 What You Need to Know

Read this section to know more about VLAN and how to configure the screens.

9.3.1 IEEE 802.1Q Tagged VLANs

A tagged VLAN uses an explicit tag (VLAN ID) in the MAC header to identify the
VLAN membership of a frame across bridges - they are not confined to the switch
on which they were created. The VLANs can be created statically by hand or
GS2200-24 User's Guide
(Section 9.4 on page 91) to view all VLAN groups.
(Section 9.4.1 on page
(Section 9.5 on page 93) to configure and view
(Section 9.6 on page
(Section 9.7 on page
(Section 9.9 on page
9

VLAN

92) to view detailed port
95) to configure the
96) to set up VLANs
102) to set up VLANs
87