ZyXEL Communications GS2200-24 User Manual page 199

screen as shown. See
Snooping VLAN.
Figure 96 Advanced Application > Multicast > Multicast Setting > IGMP Snooping
VLAN
The following table describes the labels in this screen.
Table 58 Advanced Application > Multicast > Multicast Setting > IGMP Snooping
VLAN
LABEL
Mode
Apply
Cancel
VLAN
Name
VID
GS2200-24 User's Guide
Section 24.3.3 on page 194
DESCRIPTION
Select auto to have the Switch learn multicast group membership
information of any VLANs automatically.
Select fixed to have the Switch only learn multicast group membership
information of the VLAN(s) that you specify below.
In either auto or fixed mode, the Switch can learn up to 16 VLANs .
The Switch drops any IGMP control messages which do not belong to
these 16 VLANs.
Note: You must also enable IGMP snooping in the Multicast
Setting screen first.
Click Apply to save your changes to the Switch's run-time memory.
The Switch loses these changes if it is turned off or loses power, so use
the Save link on the top navigation panel to save your changes to the
non-volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
Use this section of the screen to add VLANs upon which the Switch is to
perform IGMP snooping.
Enter the descriptive name of the VLAN for identification purposes.
Enter the ID of a static VLAN; the valid range is between 1 and 4094.
Chapter 24 Multicast
for more information on IGMP
199