ZyXEL Communications GS2200-24 User Manual page 282

Chapter 33 Access Control
Table 90 Management > Access Control > SNMP (continued)
LABEL
Security
Level
Authenticati
on
Privacy
Apply
Cancel
282
DESCRIPTION
Select whether you want to implement authentication and/or encryption
for SNMP communication from this user. Choose:
• noauth -to use the username as the password string to send to the
SNMP manager. This is equivalent to the Get, Set and Trap
Community in SNMP v2c. This is the lowest security level.
• auth - to implement an authentication algorithm for SNMP messages
sent by this user.
• priv - to implement authentication and encryption for SNMP
messages sent by this user. This is the highest security level.
Note: The settings on the SNMP manager must be set at the same
security level or higher than the security level settings on the
Switch.
Select an authentication algorithm. MD5 (Message Digest 5) and SHA
(Secure Hash Algorithm) are hash algorithms used to authenticate
SNMP data. SHA authentication is generally considered stronger than
MD5, but is slower.
Specify the encryption method for SNMP communication from this user.
You can choose one of the following:
• DES - Data Encryption Standard is a widely used (but breakable)
method of data encryption. It applies a 56-bit key to each 64-bit
block of data.
• AES - Advanced Encryption Standard is another method for data
encryption that also uses a secret key. AES applies a 128-bit key to
128-bit blocks of data.
Click Apply to save your changes to the Switch's run-time memory. The
Switch loses these changes if it is turned off or loses power, so use the
Save link on the top navigation panel to save your changes to the non-
volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
GS2200-24 User's Guide