Specific Tooling; Assembling The Clutch - MOTO GUZZI Stelvio 1200 NTX ABS Service Station Manual

Stelvio 1200 NTX ABS
Checking the clutch actuator
If the clutch is replaced, measure the length of the
clutch control rod in order to use the correct rod.
Measure as follows:
•
Fit the new clutch on the crankshaft.
•
Fit the clutch control bowl in the gear-
box.
•
Fit the gearbox on the engine block.
•
Fit the tool in the gearbox to determine
the clutch control rod length.
•
Measure rod protrusion using a depth
gauge (see picture).
•
According to the value found, select
the correct rod based on the following
table:

Specific tooling

020678Y Tool for clutch rod checking
Specification
Protrusion: 9.8 - 11.2 mm (0.386 - 0.441 in)
Protrusion: 8.3 - 9.7 mm (0.327 - 0.382 in)
Protrusion: 6.8 - 8.2 mm (0.268 - 0.323 in)
Protrusion: 5.3 - 6.7 mm (0.209 - 0.264 in)

Assembling the clutch

•
Lock crankshaft rotation with the
crankpin facing upwards.
•
Place the clutch disc with the reference
facing upwards.
•
Fasten the clutch disc on the crank-
shaft with the six screws, Loctite 243
and the belleville springs.
Revente Interdite - Revendita Vietata - Resaling Forbiden - Wiederverkauf Verboten
CLUTCH CONTROL ROD SELECTION
Clutch control rod length (code 976593) = 183 mm (7.205 in)
Clutch control rod length (code 976594) = 184.5 mm (7.264 in)
Clutch control rod length (code 976595) = 186 mm (7.323 in)
Clutch control rod length (code 976596) = 187.5 mm (7.382 in)
Desc./Quantity
ENG - 129
Engine