MOTO GUZZI Stelvio 1200 NTX ABS Service Station Manual page 83

Stelvio 1200 NTX ABS
27 of the BLUE connector: if not OK, restore the cable harness; if OK, replace the Marelli
control unit.
•
Indication on Axone always RUN: disconnect the connector and, with the switch set to
STOP, check if there is continuity between the two cables of the switch (sensor side): if there
is continuity, replace the switch; if there is not, it means that, with the key set to KEY ON,
the sky blue/orange cable is shorted to positive: restore the cable harness.
Connectors
Dashboard
The pin configuration of the GREY-bodied connector is as follows:
PIN USE
1 + KEY
2 RIGHT TURN INDICATOR CONTROL
3 HIGH-BEAM LIGHT INPUT
4 -
5 FOG LIGHTS ON (OPT)
6 K LINE
7 -
8 CONTROL - SET
9 FUEL LEVEL SENSOR
10 AIR TEMPERATURE SENSOR
11 + BATTERY
12 LEFT TURN INDICATOR CONTROL
13 -
14 -
15 -
16 GENERAL EARTH CONNECTION
17 OIL PRESSURE SENSOR INTAKE
18 SENSORS EARTH CONNECTION
Revente Interdite - Revendita Vietata - Resaling Forbiden - Wiederverkauf Verboten
Electrical system
ELE SYS - 83