MOTO GUZZI Stelvio 1200 NTX ABS Service Station Manual page 248

Braking system
Riding with an active ABS system
The warning light (7) is off. If a failure is detected,
the warning light (7) turns on permanently to indi-
cate the malfunction. The ABS device is automat-
ically deactivated. Exception: only in case of power
supply failure is the ABS warning light steadily on
but this does not mean that the ABS is actually
deactivated.
Riding with a disabled ABS system
The warning light (7) remains flashing.
ABS system deactivation. In order to disable the
ABS with the engine off and the panel on, or with
the engine on but the vehicle stopped, press the
switch (8); release the switch within 3-5 seconds
after the warning light (7) starts flashing. The warn-
ing light (7) will continue flashing. In order to ena-
ble the device again, stop the vehicle and shut off
the engine and to start-up again. The system gets
activated again after the speed goes over 5 km/h
(3.1 mph).
40A fuse (4)
Protects: the internal pump of the ABS control unit
25A fuse (5)
Protects: valve relay
Revente Interdite - Revendita Vietata - Resaling Forbiden - Wiederverkauf Verboten
BRAK SYS - 248
Stelvio 1200 NTX ABS