MOTO GUZZI Stelvio 1200 NTX ABS Service Station Manual page 194

Suspensions
Adjustment
The front suspension consists of a hydraulic fork
connected to the headstock by means of two
plates.
To set the vehicle suspension, each fork stem fea-
tures an upper nut (1), to adjust spring preloading,
and an upper set screw (2):
•
act on the right stem set screw to adjust
hydraulic rebound damping;
•
act on the left stem set screw to adjust
hydraulic compression damping.
ADJUSTMENTS
Regular adjustment (standard):
- only rider.
Medium load setting:
- (for example, rider with passenger or with luggage).
Maximum load adjustment:
- (for example, rider, passenger and luggage).
Specification
Spring preloading, nut (1) - regular load conditions
Spring preloading, nut (1) - half-load conditions
Spring preloading, nut (1) - maximum load conditions
Rebound damping, right stem set screw (2) - regular load con-
ditions
Rebound damping, right stem set screw (2) - half-load condi-
Rebound damping, right stem set screw (2) - maximum load
conditions
Compression damping, left stem set screw (2) - regular load
conditions
Compression damping, left stem set screw (2) - half-load con-
ditions
Compression damping, left stem set screw (2) - maximum load
conditions
(1) THE SETTING SHOWN IN THE TABLE MAY NEED TO BE MODIFIED ACCORDING TO THE
TYRE AND ROAD TYPE.
NOTE
(2) IF FITTED.
Revente Interdite - Revendita Vietata - Resaling Forbiden - Wiederverkauf Verboten
SUSP - 194
FORK SETTING
Regular load adjustments are the standard settings by the manufacturer:
FORK ADJUSTMENT (1) (2)
tions
Stelvio 1200 NTX ABS
Desc./Quantity
tighten (clockwise) 6 turns from fully open
tighten (clockwise) 7 turns from fully open
tighten (clockwise) 7 turns from fully open
unscrew (anticlockwise) 2 turns from fully closed
unscrew (anticlockwise) 2 turns from fully closed
unscrew (anticlockwise) 2 turns from fully closed
unscrew (anticlockwise) 2 turns from fully closed
unscrew (anticlockwise) 2 turns from fully closed
unscrew (anticlockwise) 1.5 turns from fully closed