Vehicle Preparation; Removing The Engine From The Vehicle - MOTO GUZZI Stelvio 1200 NTX ABS Service Station Manual

Engine from vehicle

Vehicle preparation

Before removing the engine block, proceed as follows:
•
Park the vehicle on its centre stand.
•
From the back, secure the vehicle with belts attached to a hoist.
•
From the front, secure the vehicle with belts attached to the handlebar and fixed to the work
bench.
•
Remove the exhaust system, the fork with the cardan shaft, the fuel tank, the rear shock
absorber, the sump guard, the engine guard, the additional headlamp supports and the
corresponding headlamps.
See also
Exhaust
Removing
Fuel tank
Removing
Additional lights
Supplementary light mount
Sump guard
Pannier mounting
Engine guard
Engine guard

Removing the engine from the vehicle

•
Disconnect the spark plug tubes.
•
Unscrew and remove the three screws
and remove the clutch control cylinder.
•
Lock the cylinder using a clamp to pre-
vent oil leaks.
Revente Interdite - Revendita Vietata - Resaling Forbiden - Wiederverkauf Verboten
ENG VE - 86
Stelvio 1200 NTX ABS