Installing The Cylinder - MOTO GUZZI Stelvio 1200 NTX ABS Service Station Manual

Engine
•
Insert the pin.
•
Insert the snap ring.
Specific tooling
020470Y Pin snap ring fitting tool

Installing the cylinder

RIGHT CYLINDER
•
Fit the piston.
•
Remove the cloth used to prevent for-
eign bodies from getting into the crank-
case.
•
Turn the rings so that the coupling ends
are 120 degrees from each other.
•
Place a new metal gasket between the
crankcase and the cylinder. Place the
two dowel pins on the stud bolts. Lu-
bricate the piston and the cylinder.
Lock connecting rod motion with the
fork tool. Using the suitable piston ring
clamp tool, place the cylinder and fit the
chain in the timing system plate.
CAUTION
DURING THIS OPERATION, PAY ATTENTION NOT TO
DAMAGE THE PISTON.
Specific tooling
020674Y Piston ring clamp
Revente Interdite - Revendita Vietata - Resaling Forbiden - Wiederverkauf Verboten
ENG - 154
Stelvio 1200 NTX ABS