Removing The Exhaust Manifold - MOTO GUZZI Stelvio 1200 NTX ABS Service Station Manual

Stelvio 1200 NTX ABS
•
Remove the exhaust end.
Removing the manifold - tail pipe
•
Remove the exhaust end and the ex-
haust manifolds.
•
Remove the starter motor protection in
order to disconnect the lambda probe
connector.
•
Unscrew and remove the nut and re-
move the fixing screw.
•
Remove the manifold - exhaust end
coupling together with the lambda
probe.
See also

Removing the exhaust manifold

Removing the tail pipe
Removing the exhaust manifold
The engine and the exhaust system components get very hot and remain in this condition for a certain
time interval after the engine has been switched off. Before handling these components, make sure that
you are wearing insulating gloves or wait until the engine and the exhaust system have cooled down.
Revente Interdite - Revendita Vietata - Resaling Forbiden - Wiederverkauf Verboten
Chassis
CHAS - 239