MOTO GUZZI Stelvio 1200 NTX ABS Service Station Manual page 39

Stelvio 1200 NTX ABS
•
For the rear brake, keep the vehicle upright so that the fluid in the reservoir is at the same
level with the plug.
•
Make sure that the fluid level in the reservoir is above the "MIN" reference mark:
MIN = minimum level
MAX = maximum level
If the fluid does not reach at least the "MIN" reference mark:
•
Check brake pads and disc for wear.
•
If the pads and/or the disc do not need replacing, top-up the fluid.
Top-up
Front brake:
•
Unscrew the two screws (1) of the
brake fluid reservoir (2) using a Phillips
screwdriver.
•
Lift and remove the cover (3) and
screws (1) as well.
•
Remove the gasket (4).
Rear brake:
•
Unscrew and remove the cap (5).
•
Remove the gasket (6).
•
Top-up the reservoir with brake fluid to
the correct level, which is between the
two "MIN" and "MAX" reference marks.
RISK OF BRAKE FLUID SPILLING. DO NOT OPERATE THE
BRAKE LEVER IF THE BRAKE FLUID RESERVOIR CAP IS
LOOSE OR HAS BEEN REMOVED.
CAUTION
AVOID PROLONGED AIR EXPOSURE OF THE BRAKE
FLUID. BRAKE FLUID IS HYGROSCOPIC AND ABSORBS
MOISTURE WHEN IN CONTACT WITH AIR. LEAVE THE
BRAKE FLUID RESERVOIR OPEN ONLY FOR THE TIME
NEEDED TO COMPLETE THE TOPPING-UP PROCEDURE.
TO AVOID SPILLING FLUID WHILE TOPPING-UP, KEEP
THE TANK PARALLEL TO THE RESERVOIR EDGE (IN
HORIZONTAL POSITION).
DO NOT ADD ADDITIVES OR OTHER SUBSTANCES TO
THE FLUID.
Revente Interdite - Revendita Vietata - Resaling Forbiden - Wiederverkauf Verboten
Maintenance
MAIN - 39