MOTO GUZZI Stelvio 1200 NTX ABS Service Station Manual page 159

Stelvio 1200 NTX ABS
•
Fit the gasket with the correct thick-
ness between the head and the cylin-
der.
•
Fit the right cylinder head.
•
Unscrew and remove the right chain
tensioner cap.
•
Screw two screws in the threaded
holes of the timing system upper gear.
•
Rotate the camshaft so that its pin is
aimed towards the hole in the timing
system chain.
•
Place the gear in the chain.
•
On the right camshaft pin, fit the hole
marked with the letter "R" of the timing
system gear.
•
Screw the cap of the right chain ten-
sioner.
•
Undo and remove the screws used to
place the gear on the camshaft.
•
Place the bulkhead and align the holes
with the timing system gear.
•
Fix the bulkhead on the timing system
gear using a screw with Loctite on the
thread.
•
Tighten the screw to the prescribed tor-
que.
•
Also place the bulkhead of the other
head.
Revente Interdite - Revendita Vietata - Resaling Forbiden - Wiederverkauf Verboten
Engine
ENG - 159