MOTO GUZZI Stelvio 1200 NTX ABS Service Station Manual page 218

Chassis
Installing
•
Spread a thin layer of lubricating
grease all along the swingarm pin.
•
Fit the ring nut in the swingarm pin and
screw it manually.
•
Working from both sides, grease the
cardan shaft cables with the recom-
mended product from the recommen-
ded products table.
•
Block the swingarm, insert the univer-
sal joint, align the holes and, at the
same time, helped by a second opera-
tor, insert the pin completely.
•
Tighten the swingarm pin.
•
Use the suitable box-spanner to tight-
en the ring nut.
Specific tooling
05.91.26.30 Tool for tightening the swingarm
pin ring nut - clutch hub
•
Tighten the two swingarm terminal
screws.
Revente Interdite - Revendita Vietata - Resaling Forbiden - Wiederverkauf Verboten
CHAS - 218
Stelvio 1200 NTX ABS