Radiator Removal/Installation - Mazda 3 Workshop Manual

Mazda 3 Workshop Manual – Engine + Wiring Diagrams + Diagnostic Trouble Codes
4. Hold the cooling system cap downward and apply pressure gradually. Verify that the pressure holds
for 10 s.
• If the pressure is not held stable within the specification, replace the cooling system cap.
Pressure
Z6: 90-110 kPa
{0.92-1.12 kgf/cm
LF: 135-155 kPa
{1.38-1.58 kgf/cm

RADIATOR REMOVAL/INSTALLATION

Warning
• Remove and install all parts when the engine is cold, otherwise they can cause severe burns or
serious injury.
1. Remove the battery cover. (See
REMOVAL/INSTALLATION
2. Disconnect the negative battery cable.
3. Remove the under cover.
4. Drain the engine coolant. (See
5. Disconnect the coolant reservoir hose from the radiator.
6. Position the front wiring harnesses out of the way.
7. Remove in the order indicated in the table.
8. Install in the reverse order of removal.
9. Add engine coolant. (See
10. Inspect for engine coolant leakage. (See
Downloaded from
2
, 13.1-15.9 psi}
2
, 19.6-22.4 psi}
BATTERY REMOVAL/INSTALLATION
[LF].)
ENGINE COOLANT
ENGINE COOLANT REPLACEMENT.)
ENGINE COOLANT LEAKAGE
https://carmanualshub.com/
[Z6].) (See
REPLACEMENT.)
INSPECTION.)
- automotive repair manuals website
B3E011215200W01
BATTERY