Rep 5.5 Configuration Card; Rep 5.6 Circuit Boards (Power Supply, Main Controller, Power Control) - Xerox ColorQube 8570 Service Manual

REP 5.5 Configuration Card

Parts List on PL 5.1 Item 5
Removal
Handle the Configuration with care to prevent damaging the Card.
1. Remove the I/O Access Door (REP
2. Press the Configuration Card towards the rear of the printer at angle and pull the Configu-
ration Card out from the Electronics Module.
Figure 1 Removing the Configuration Card
Repairs and Adjustments
REP 5.5, REP 5.6
CAUTION
1.13).
REP 5.6 Circuit Boards (Power Supply, Main Controller,
Power Control)
Parts List on PL 5.1 Item
Removal
Be sure to disconnect AC power prior to disassemble the Electronics Module.
Touch the Electronics Module to discharge any static electricity before servicing the printer.
The circuit board is vulnerable to ESD. Review the
dures in the Introduction Chapter.
1. Remove the Control Panel Cover
2. Remove the Left Side Cover
3. Remove the Right Side Cover
4. Remove the Exit Cover (REP
5. Remove the Ink Loader (REP
6. Remove the Electronics Module
7. Remove 2 thumbscrews that secure the Rear Panel and remove the Rear Panel.
8. Disconnect the Hard Disk Drive wiring harness connectors from the Main Controller
Board (if a Hard Disk Drive is installed).
Figure 1 Removing the Rear Panel
October 2012
4-88
6, PL 5.1 Item 7, PL 5.1 Item 8
WARNING
CAUTION
CAUTION
Electrostatic Discharge Precautions
(REP 1.5).
(REP 1.10).
(REP 1.11).
1.7).
1.8).
(REP 5.1).
Revised, 3rd Revision - Xerox Internal Use Only
ColorQube 8570/8870 Service Manual
proce-