Table of Contents
Advertisement
BIOS
The settings in the BIOS Setup utility are not retained
■
Replace the CMOS battery. For instructions, see
page
84.
CD drive
Your server does not recognize a CD or the CD drive
■
Restart your server, then open the BIOS Setup utility by pressing and holding F2 while
your server restarts. Make sure that the IDE controllers are enabled. For more
information, see
■
Reinstall the device driver. For instructions, see
on page
33.
■
Make sure that the drive is configured correctly by following the instructions in the
drive's documentation.
■
To check the installation, see
"Removing a CD or DVD drive" on page 52.
Your CD drive tray does not open
■
Press a straightened paper clip wire into the CD drive's manual eject hole. The drive
tray opens.
■
If this problem happens frequently while the server is turned on, the drive may be
defective.
Diskette drive
The diskette drive is not recognized
■
Restart your server.
■
To check the installation, see
page 45
and
page
49.
The diskette drive LED is lit continuously
■
Remove the diskette from the drive. If the light stays on, try restarting your server.
■
To check the installation, see
page 45
and
page 49.
118
"Using the BIOS Setup Utility" on page
"Installing a CD or DVD drive" on page 50
"Installing a diskette in a converted hard drive bay" on
"Removing a diskette drive from the converted hard drive bay" on
"Installing a diskette in a converted hard drive bay" on
"Removing a diskette drive from the converted hard drive bay" on
www.gateway.com
"Replacing the CMOS battery" on
91.
"Using your System Companion CD"
and
Advertisement
Table of Contents
Troubleshooting
