Dsp Configurator Program Basics; Starting The Program; Using The Program - Extron electronics DMP 128 User Manual

DSP Configurator Program Basics

Starting the Program

NOTE: Extron recommends connection via the Ethernet LAN port for running the
To run the DSP Configurator Program, click
Start > Programs > Extron Electronics > DSP Configurator > DSP
Configurator.
Select the DMP 128 model and click OK.
DSP Configurator starts in Emulate mode (see
Mode and Live Mode

Using the Program

In the DSP Configurator Emulate mode, audio parameters can be selected and transferred
to the DMP 128 by switching to Live mode (while connected to a DMP 128) and pushing
the configuration. Audio settings can also be tailored while connected to the DMP 128 for
real-time auditioning of the audio output as adjustments are made
(see
DSP Configurator Main Screen
The main screen contains controls for the input and output channels, virtual sends and
returns, expansion outputs and inputs, and other information used in the operation of the
DMP 128. There is too much information contained on the main screen to enable viewing of
the entire mix board at one time, so several methods, outlined on the following pages, are
provided to scroll through the screen.
DSP Configurator program.
on page 90).
Emulate Mode and Live Mode
figure 16, next page, and see
on page 90).
DMP 128 • Software Control
Emulate
18