Dante Installation And Operation (At Models); Dmp 128 At Bus - Extron electronics DMP 128 User Manual

Dante Installation
and Operation
(AT Models)
This section describes the DMP 128 AT network installation, configuration, and control using
Dante Controller for Windows and includes:
•
•
•
•
•
•
•
•
DMP 128 AT Bus
DMP 128 devices equipped with an AT bus use Dante technology to provide high
performance digital audio networking over standard TCP/IP networks. Dante allows audio
channels to be transported across a switched Ethernet data network while meeting the
quality requirements of professional audio.
Audio signals are converted by the DMP 128 AT models, processed and routed to the AT
bus for availablity over the network. The audio network can be shared with control traffic or
unrelated data traffic. Audio channels can be unicast or multicast to make the best use of
available bandwidth.
The DMP 128 AT models are both a transmitter (source), and receiver (destination) for
signals on a Dante network. Transmitters and receivers can be located anywhere on the
Ethernet network and can be relocated without reconfiguring the DMP 128 AT or the
network.
DMP 128 AT Bus
Dante Controller Software Installation
Creating a Physical Dante Network
Dante Controller Configuration
Selecting Inputs and Outputs for Dante
Signal Routing with Dante
Using the Extron Expansion Bus with DMP 128 AT Devices
Viewing AT Channels with AT Meters
DMP 128 • Dante Installation and Operation 113