Tools - Extron electronics DMP 128 User Manual

Tools

The Tools menu (see right) contains these selections:
• Clear All Groups — clears
all group members and group
master parameters. Soft limits
are also cleared.
• Increment/Decrement
Simulator — allows the user
to test increment/decrement
values (see below for more
information)
• Refresh All Group Data — Updates group members and group master
parameters.
• Group Details Report — generates a report, listing all group masters and
membership (see
Increment/Decrement Simulator
The Increment/Decrement Simulator provides a control for increment and decrement, with
the ability to set increment and decrement values. The control is temporary, since the value
is not remembered in the device.
To use the Increment/Decrement Simulator:
1. Select Tools > Increment/Decrement Simulator.
2. Select the group to be controlled from the Select Group drop-down list. The following
dialog box opens:
Figure 58.
NOTE: The Number of Group Members: readout indicates the number of
controls affected.
3. Enter an increment value and a decrement value. The default value is 1.
NOTE: The size of the increment can be changed by typing a value in the
Increment Value or Decrement Value field. Values can be as large as the
maximum range of the control or as fine as 0.1 dB. For groups controlling mute, 1
is the only valid value.
4. Click Increment and Decrement as needed. The group master control increases or
decreases by the set value to the top or bottom of its soft limit range.
NOTE: When set, soft limits cannot be exceeded.
Group Details Report
Increment/Decrement Simulator Dialog Box
on page 88).
DMP 128 • Software Control 87