Simple Control Port Commands - Telnet And Web-Browser Accessible - Extron electronics DMP 128 User Manual

Simple Control Port Commands - Telnet and Web-Browser Accessible

Upper and lower case text can be used interchangeably except where noted. Port 23
is default for Telnet. Port 80 is default for Web browsers. They both can be mapped to
different ports.
There are minor differences when implementing these commands via Telnet or via URL
encoding using a Web browser. All commands listed will work using either connection
method but due to some limitations of Web browsers, the encapsulation characters must be
modified to be certain the Web browser properly handles them. All examples are shown in a
proper implementation of a Telnet or Web browser session.
NOTE: When using Web browsers, some non-alphanumeric characters must be
represented as their hex equivalent such as %xx where xx equal the two character
representation of the hex byte that needs to be sent (a comma ',' would be
represented as %2C). Characters such as '%' (percent), '+' (plus) and ' ' (space)
should also be encoded in Hex.
Telnet
Escape (Hex 1B)
Carriage Return (Hex 0D)
When describing the use of SIS commands via a Web browser, the [URL] reference is used
to shorten the examples. [URL] would be the full URL of the control interface and Web page
reference including all path information
(http://192.168.254.254/mypage.HTML).
To send commands using a Web browser, prefix them with the full URL followed by ?cmd=
(http://192.168.254.254/mypage.html?cmd=WSF>).
Although the DMP 128 uses the same structure for SIS commands, there are two variations.
One is the global command structure noted above and documented in the
Response Tables
The second set of tables, "DSP SIS commands," uses the command structure outline
beginning with
Generally, the basic SIS commands are for global configuration such as setting IP addresses
or date and time, while the DSP SIS commands address audio processing functions.
Web Browser
W [must not be encoded]
Pipe Character (
encoded]
that immediately follows.
DSP SIS Commands on page 141.
) [must not be
|
DMP 128 • SIS Programming and Control
Command and
134