Selecting Live Mode And Pushing Or Pulling Data - Extron electronics DMP 128 User Manual

Selecting Live Mode and Pushing or Pulling Data

To switch from Emulate to Live mode:
1. Select the desired connection to the DMP 128 and make the proper connections.
NOTE: Extron recommends connection via the Ethernet LAN port when using
DSP Configurator.
2. Click Live (see figure 62,
2 2
3 3
ã ã
ä ä
å å
Figure 62.
3. To select the connection method, click:
TCP/IP (for connection of the LAN port (preferred) — proceed to step 4
•
RS-232 (for connection of the rear panel RS-232 port — proceed to step 5
•
USB (for connection of the front panel configuration port — proceed to step 6
•
4. If TCP/IP is selected in step 3:
a. Observe the IP address field in the IP connection dialog box. The field displays
the last IP address entered.
•
•
b.
If the device is password protected, click in the Password field and enter the
appropriate administrator password
c. Click OK.
The Synchronize with Device dialog box (see
Proceed to step 7.
). The communication type selection dialog opens.
2
3 3
ê ê
ë ë
or
ì ì
Selecting Live Mode
If the IP Address field is correct, proceed to step 4b
If the address is not correct, either click in the IP Address field and enter
the correct IP address or click ( ) to open a drop-down list and select from
among recently used addresses. Proceed to step 4b
NOTE: If the local system administrators have not changed the value,
the factory-specified default, 192.168.254.254, is the correct value for
this field.
3 3
ò ò
or
ó ó
figure 63 on page 93) opens.
DMP 128 • Software Control 91