Extron electronics DMP 128 User Manual page 98

5. If RS-232 is selected in step 3:
a. Click the Com Port drop-down list and select the port connected to the rear panel
RS-232 port.
b. Check the baud rate displayed in the port selection dialog box. If the baud rate
does not match the device rate, click the Baud Rate drop-down list and select the
desired baud rate. The default is 38400.
c. Click OK.
The Synchronize with Device dialog box (see figure 63 on next page) opens.
Proceed to step 7.
6.
If USB is selected in step 3:
a. Click the USB Device drop-down list and select DMP 128 (or Extron USB
device, if a DMP 128 is not available),
b. Click OK.
The Synchronize with Device dialog box (see figure 64 on next page) opens.
Proceed to step 7.
DMP 128 • Software Control 92