Dante Controller Configuration; Start Dante Controller - Extron electronics DMP 128 User Manual

Dante Controller Configuration

Now that the DMP 128 ATs are configured for network operation and the Dante software is
installed, Dante Controller must be configured.

Start Dante Controller

To launch Dante Controller.
From the DSP Configurator menu bar, select Tools > Network Audio Control (see
figure 88,
Dante Controller opens. If the network has a DHCP server, it receives its IP configuration
using the standard DHCP protocol. On a network without a DHCP server, a Dante-enabled
device automatically assigns itself an address using link local protocols.
Once connected, Dante Controller begins to auto-discover other Dante devices. While
scanning the network, it also advertises itself to allow other Dante-enabled devices to see
and communicate with it.
).
1
Figure 88. Network Audio Control
1 1
DMP 128 • Software Control 119