Dmp 128 At Expansion Bus (At Inputs) - Extron electronics DMP 128 User Manual

The DMP 128 output lines are always the first eight transmitter lines (Outputs 01 through 08
in figure 93,
appear in the Dante transmitter list (see figure 93,
The eight virtual sends of the DMP 128 (
EXP_Out-16.
Figure 93.
DMP 128 AT Expansion Bus (AT Inputs)
Dante
There are a total of 56 DMP 128 EXP inputs that can be routed.
Receivers
Dante Receivers (Rx)
5
Figure 94.
In figure 94, expansion inputs that accept signals on the AT bus from the Dante receiver
channels are outlined.
NOTE: Figure 94 shows only the first 16 of 56 total expansion inputs. Routing of inputs
not shown is the same.
). The eight expansion outputs (see
4
Dante Transmitters
DMP Expansion Bus AT Inputs
DSP Configurator Expansion Inputs (Dante Receiver EXP_In)
figure 92, on the previous page)
2
), as EXP_Out-01 to EXP_Out-08).
4
) appear as EXP_Out-09 through
3
AT Inputs 17 to
AT Inputs 56
DMP 128 • Software Control
Dante
Transmitters
4 4
Connection
6
Points
124