Extron electronics DMP 128 User Manual page 30

View menu
• Meter Bridge — Opens a Meters dialog box with
real-time meters that monitor signal levels at each input
and output.
Figure 18. Meter Bridge
NOTE: Meter Bridge is available in Live mode only while connected through the
LAN port.
• Re-enable All Dialogs — Re-enables all dialog boxes, the pop-ups that allow
changes to block parameters.
• Group Controls — Opens the Group
Controls dialog box (see
page 83).
• AT Meters
(AT models only) — Allows the user to view the AT
meters for an attached Dante device.
To view the meters:
1. From the main DSP Configurator toolbar,
select View > AT Meters.
2.
The Browse and Select the Device
dialog box opens (see right).
3. Double-click the applicable device. The meter display opens showing the Tx and Rx
channels. See Viewing AT Channels with AT Meters
information.
• Show All Channels — Enables channels previously hidden from the main menu to
be viewed. The selection provides an option to either show all hidden channels for that
selection, or by moving to the right, an individual channel can be selected while leaving
the others hidden.
Group Masters on
DMP 128 • Software Control
on page 126 for addtional
24