Deleting A Group Master; Viewing And Using A Group Master; Add A Group - Extron electronics DMP 128 User Manual

Deleting a Group Master

To delete a group:
1. Click Tools > Configure Groups (see figure 57) to open the configure groups dialog
box
or click View > Group Controls and then click Add a Group.
2. In the Select Group drop-down list, click a numbered group (such as Group #1).
3. Click Delete Current Group in the lower left area.
4. Click Yes in the Confirm Deletion dialog box.

Viewing and Using a Group Master

Click View > Group Controls to open the group controls dialog box (see figure 58). The
group controls dialog contains two menu items:
• Add a Group allows you to add additional groups.
Tools enable you to perform various functions from the Group Controls dialog box.
•
In addition, once groups are created, a single mute button or a group fader plus the current
setting readout and any soft limits are visible.
Figure 57.
The group fader controls function as follows:
Slide a group fader up and down to adjust all gain controls in the group.
•
• Click and drag a soft limit ( ) to set the ceiling and floor for the group.
NOTE: Soft limits cannot be dragged beyond the current setting of the group fader.

Add a Group

To launch the Configure Groups dialog box from group controls, click
Add a Group. When a new group is added and the Add New Group dialog is closed, the
Group Controls dialog box refreshes to display the added control.
NOTE: If a block is previously muted, that block remains muted when the group mute
is released.
Group Controls Dialog Box
DMP 128 • Software Control 86