Sis Command And Response Table For Dsp Mix-Point And Level Control - Extron electronics DMP 128 User Manual

SIS Command and Response Table for DSP Mix-Point and Level Control

Setting the level of a mix-point requires the mix-point address and level value. Making a
connection between a mix-point input and output requires the mix-point be unmuted.
Command ASCII command
(host to device)
Audio level control, and mix-point selection
NOTES:
The command format is the same, regardless of the control or mix-point to be set; the acceptable adjustment range of the
main mix-points is -35 dB to +25 dB, in 0.1 dB increments.
All responses are shown with the DMP 128 in Verbose mode 2 or 3.
Set a mixpoint trim E
or gain
Example 1 Input 1 E
to Virtual Send A
gain:
Example 2 E
mix-point gain:
Read a mix-point E
level
E
Example 1
Input 11 to
Output 8:
Example 2 E
Input 3 to
Output 4:
Audio mute
NOTE: All responses are shown with the mixer device in Verbose mode 2 or 3.
Audio mute E
Example: E
Input 4 to
Output 2:
Audio unmute E
Read mute status E
NOTES:
X6)
= Mix-point select (see
X6!
= Signal level value in dB (see
X6$
0
= Mute status,
Response
(device to host)
X6) X6! }
G * AU DsG
* }
G20009 2040AU DsG20009*2040
}
G20001*2213AU DsG20001*2213
X6) }
G AU DsG
}
G21007AU DsG21007*2103
}
G20203AU DsG20203*2140
X6) }
M *1AU DsM
}
M20301*1AU DsM20301*1
X6) }
M *0AU DsM
X6) }
M AU DsM
table 3 on page 176 through
table 2 on page 150)
1
= unmute = mute
Additional description
X6) X6!]
*
Set trim or mix control
of
] Set Input 1 to Virtual Send A gain to
a value of -0.8 dB.
]
Mix +16.5 dB of input 1 into output 2.
X6) X6!]
*
Mixpoint
X6!
]
Mix-point In 11 to output 8 is set to a
value of +5.5 dB.
] +9.2 dB of In 3 is mixed to output 4.
X6) ]
*1
Mute mix-point
] Mute mix-point input 4 to output 2.
X6) ]
*0
Unmute mix-point
X6) X6$]
*
table 10 on page 198)
DMP 128 • Reference Information
X6)
to a value
X6!
dB.
X6)
is set to a value of
dB.
X6)
.
X6)
.
173