Dante Device Discovery - Extron electronics DMP 128 User Manual

Dante Device Discovery

The Tools menu also provides a way to locate other Dante devices on your network. Once
the device is named (see
identified as a Dante host from any other Dante device.
Once the device is located, select the device. The input expansion channel names from the
device are imported from Dante Controller into DSP Configurator.
To locate Dante devices on an audio network:
1. Select Tools > Device Settings. The
Device Settings dialog opens.
2.
Select the Dante Device tab.
3. Dante devices are found by either:
a. Entering the name in the AT name: field,
-or-
b. Click Search for Dante components to
start a search.
The search may take a few minutes.
As new devices are discovered, they are listed in
the window.
4. If you are using the EXP port to connect to
a non AT DMP 128, check the Use Extron
Expansion Bus for channels 41-56 box
(see Using the Extron Expansion Bus with
DMP 128 AT Devices
5. Click Apply or OK.
Dante Network Audio Setup
on page 126).
on page 114), it can easily be
Dante Device
To identify your AT component, enter the
name below or click the button below to
search your local network.
DMP128MASTER
AT name:
Search for Dante Components
DMP 128 • Software Control 116